BELT BRUSH

The electric roller brush cleaner is suitable for various types of bandwidth conveyors. It is used to clean the working surface of the return belt or unload the lower belt of the roller. It can effectively clean the surface of the roller and the bottom of the belt. The brush tip is in slight contact with the belt surface. The rotation direction is opposite to the running direction of the return conveyor belt, so that the particulate material sticking to the belt surface is brushed down to achieve the purpose of thorough cleaning.

Parameter:

1Belt Width:650~1400(mm)

2 Material humidity:≤5%

3 Suitable for various belt speeds

4 Suitable for patterned belts and flat belts

5electric voltage:380VAC±10%

6 Rated Power:1.5kw

Its main advantages are as follows:

It can basically completely clean the residual material on the belt after the belt is changed to the rear by the roller. It must be similar to the traditional scraper cleaner.
The cleaning effect can be improved by 70%. Greatly reduce the friction between the belt, the roller and the lower supporting roller, which is conducive to ensuring that the belt and the roller are used to reach their design life, which can increase the service life of the lower supporting roller by more than 50%, and thereby bring the most cost to the unit The savings are far greater than the cost of the cleaner.
Effectively improve the damage of the traditional scraper cleaner to the belt interface and the peeling of the old belt.
Improve the working environment, reduce the labor level of workers, and reduce the hidden dangers of safe production at complex sites.
1.The roller brush can be replaced. The use cost of this product after one installation is only the cost of replacing the roller brush, which is basically equivalent to the cost of a traditional scraper cleaner.

Check out our work

Comparison

Belt

L1

L2

500

500

850

650

650

1000

800

800

1300

1000

1000

1500

1200

1200

1700

1400

1400

2100